Auto Trim Design

Pricing transparency matters more than the cheapest quote — a clear written estimate beats a vague round-number bid. Auto Trim Design shows up in Memphis, TN as a window tinting candidate worth scoping before booking. The notes below separate public-source documentation from what still needs to come from the dispatch line. Documented service cues here: lifetime warranty, paint protection film. The provider should be able to explain pricing differences across these on the call. No structured homeowner use-case mapping is on file. Ask the dispatch what their typical recent jobs are — small repairs, full replacements, or commercial maintenance contracts. Ask whether the provider leaves a written report after each visit listing what was done, what was found, and what to watch next. Without that, the next provider has to re-diagnose from scratch. SRS Racing Film Guide does not certify this provider or promise outcomes. The page summarizes public-source signals and editorial questions to make the dispatch call more productive.

Address

1552 Getwell Rd, Memphis, TN 38111, United States

Phone

+1 901-743-3122

Website

atdmemphis.com/

Source depth

79 of 100

Indexable

Standalone profile

TN sits in the Mid-tier band. Most U.S. states sit between 30 and 50 percent on the front-window VLT minimum. The numbers vary state by state, so the safe move is to ask the shop to install at or above your state's legal floor and to check the most recent vehicle code text — laws change.

Across all fifty states, the only zone of the windshield where any non-reflective tint is legal is the strip above the AS-1 line — usually four to five inches at the top, marked on factory glass with a small "AS-1" etching. Below that line, windshield tint is not street-legal anywhere in the United States, regardless of state side-glass rules. A reputable shop will measure from the AS-1 line down before laying film, not from the top of the glass.

Laws change. Confirm the most recent VLT minimum directly with the shop and, when in doubt, with the most recent text of your state's vehicle code.

1. Get PPF and tint quoted as separate jobs.Paint protection film and window tint are different installs in different bays with different cure windows. Bundling them on one invoice is fine, but the timeline and warranty paper should be split. Ask which film brand the PPF crew installs (XPEL, SunTek, STEK).
2. Read the lifetime warranty before signing.Most "lifetime" wording in tint covers fade, bubbling, peeling, and cracking — not stone chips, edge lift from worn window seals, or ammonia-cleaning damage. Some are original-owner-only; others transfer with a small fee. The transferable clause is what protects resale.
3. Confirm the shop measures front-window VLT before install.A shop that measures with a photometer before installation is the one most likely to keep you legal in your state. If they ask you to sign that compliance is on the customer, that's a quiet yellow flag. Tint stops are 30–50 % on the front in TN.
4. Ask the cure time and what to do during it.Newly installed film cures for 3 to 5 days in summer, 7 to 10 in winter. During cure, do not roll windows down — the film can shift and the squeegee margins can lift. Light hazing or small water bubbles in this window are normal and clear up; bubbles after 30 days are not.
5. Verify the AS-1 line on your windshield before booking strip tint.Across all 50 states, the only zone of the windshield where any tint is legal is above the AS-1 line — usually marked with a small "AS-1" etching at the top of factory glass. Below the AS-1 line, no tint is street-legal anywhere in the U.S., regardless of your state's VLT rule on side glass.
6. Pull a window seal vs. cut on glass — ask what the shop does.Cut-on-glass installs save 15 minutes but risk scoring the rubber seal with a razor. The cleaner method pulls the rear-side or rear-glass window down a half-inch so the cut happens off-glass. It costs the shop time, not money — confirm during the quote.